����������
����
H1
H
12c
12a
12b
N
12
S
Assembling the satellite dish on the motor
• Assemble the satellite dish and fix it on the motor’s mast. The satellite dish U-Bolt
must be the highest as possible on the angled arm to avoid the bottom of the dish to
touch the motor. As the motor is at 0°, make sure you perfectly align the dish offset
arm with the motor (schema H1).
• Direct approximately the whole (satellite dish + rotor) towards the south. At this level,
it is not necessary to tighten the nuts too much. Tighten up the lock nut 12a to the
maximum (see schema 12). Tighten the elevation nut 12b to bring the satellite dish
in vertical position. Check again that the satellite dish elevation is at 54° (graduation
12c) and that the satellite is vertical whatever the way (lateral and incline).
• Switch on the receiver, put it on the Hotbird reference channel while pressing 0072 on
the remote control.
• Do a continuing rotation
(4)
until the stop 45° East and 45° West to check if there is no
obstacle. If you get close from an obstacle during the spin, go back to paragraph 15
page 28 to adjust your mechanical stop.
Assembling the LNB head (See § D page 5)
I
(4)
See the paragraphs on the
page 9.
15
Содержание (Re)playBox
Страница 2: ......
Страница 40: ...NOTES 38 ...
Страница 51: ......
Страница 52: ...Node Park Touraine BP 1 TAUXIGNY 37310 REIGNAC SUR INDRE CEDEX FRANCE www metronic com Product made in Asia ...