Assembing the motor (See schema 2)
• Make sure the fixing (tube or stand off arm) is stabilised and strictly vertical. A gap
of more than 1 degree (2cm, 0,78” per meter) from the vertical will prevent the
motor to work correctly. In case, add some block between the wall and the fixing.
Check the verticality with a spirit level or a plumb line.
Warning:
When you will screw the screw 2C (which must not be blocked), a too
important tightening might break one of the support clamps.
When the motor is assemble, do not fix it straight away on the mast or the stand off
arm, some operations needs to be done near the receiver.
• Screw on all the screw without blocking it. The screw 2b must be tighten at the
maximum and the cover 2a must be leave up to allow you to read the motor azi-
muth (angle in relation to south)
Warning: the screw 2b must get in by the small hole in the bend mast and the nut
must be tighten on the big hole side, with the rounded nut moulded the curves of the
big hole.
• Adjust the motor elevation (read near 2d) on around 35°.
��
��
��
��
��
��
��
��
��
��
2
C
11
Содержание (Re)playBox
Страница 2: ......
Страница 40: ...NOTES 38 ...
Страница 51: ......
Страница 52: ...Node Park Touraine BP 1 TAUXIGNY 37310 REIGNAC SUR INDRE CEDEX FRANCE www metronic com Product made in Asia ...