Metronic AccessBox, Руководство пользователя

Страница: 9 / 24

8
CONNECTION ON A MOTORISED DISEQC 1.2 UNIT ALREADY ALIGNED
Connect the cables and the leads as indicated on the figure below (figure #5).
When 2 satellite receivers control the same motor, it is important that each one of
them give the same number to a given satellite. For an easiest installation of your
new digital receiver, locate the classification of the satellites used by your analogue
demodulator.
For each satellite you want to receive in digital, it is necessary to proceed as follows:
Example on HotBird
• Go on the reference channel (see figure n°1 page 5) satellite by typing the channel num-
ber then OK. Example: 022 for HotBird.
• Go in MENU / INSTALLATION / LNB & SWITCHES SETUP
• Check that the Satellite line displays the satellite in question (ex HotBird).
• Check that the line DiSEqC 1.2 displays
ENABLE. If it is not the case, modify the dis-
play with the key.
• On the line MOTOR CONTROL , choose the function POSITION with the keys and
enter the HotBird number for your analogue demodulator.
Press on OK and confirm on
YES
to memorise and wait until the motor stops spinning.
• If your motor were correctly aligned, and that you entered the right number for HotBird,
the signal indicator must be green. If it is not the case, check your alignment with the
analogue receiver.
• Press on EXIT to leave the menus and check that you receive the HotBird channels cor-
rectly.
• Do the same thing for the other satellites.
figure 5
OR
If you don’t have any analogue receiver, connect directly Access BOX to the TV.
6
Ntc Accessbox-GB 3/11/03 8:44 Page 9