Metronic AccessBox, Руководство пользователя

Страница: 7 / 24

6
INSTALLATION OF A DUAL-HEAD SATELLITE DISH ASTRA 19.2 + HOT
BIRD
Install the dual-head support in such a way that, when you look at the satellite dish, the
shifted head is on the left.
Initially, proceed in the same way as for a mono-head satellite dish (see preceding page),
by directly connecting the receiver to the central LNB with only one cable and by aligning
your satellite dish on Hot Bird.
Installation with a Tone Burst or DiSEqC 1.0 switch
When you receive all the Hot Bird channels correctly (satellite n°4) with the central head,
disconnect the cable of this head and connect it on the I/O port of the DiSEqC Tone Burst
switch.
Prepare two cables of approximately 1,5 m and screw an “F” plug at each end.
Connect the main head to the switch LNB A input and the head shifted with the input LNB
B You will now register the switch in the receiver menus:
• Go in MAIN MENU /
INSTALLATION / LNB & SWITCHES SETUP
• Go on Satellite name and press OK to show the satellites list. Select Hot Bird and vali-
date by OK.
• Go on
DiSEqC 1.0,1.1
and press on until
A
is displayed.
• Press OK to memorise,
SUCCESSFULLY UPDATED
appears.
• Go on Satellite name and press OK to display the satellites list. Select
Astra1, 19.2°
and
validate by OK
• Go on
DiSEqC 1.0,1.1
and press until
B
is displayed press OK to memorise,
SUC-
CESSFULLY UPDATED appears.
• Press EXIT to leave all the menus.
You can now watch all the pre-programmed Astra 19.2 and Hot Bird channels (see "daily
use”).
Installation with a DiSEqC 1.0 monobloc
• Go in MENU / INSTALLATION / LNB & SWITCHES
SETUP
• Go Satellite then press OK to display the channels list.
Select HOT BIRD then validate by OK.
• Go on DiSEqC 1.0,1.1 and press until A is displayed.
• Press OK to memorise, SUCCESSFULY UPDATE
appears.
• Go on satellite then press OK to display the satellites list.
Select Astra1,19.2° and validate by OK.
• Go on DiSEqC 1.0,1.1 and press until B is displayed.
• Press OK to memorise, SUCCESSFULY UPDATE appears.
• Press EXIT to leave all the menus.
• Do the alignment on HotBird as explained the preceding paragraph (fixed satellite dish
on a satellite).
• Once you have received HotBird, you should automatically receive the Astra channels.
Sometimes, it is necessary to adjust the alignment to optimise the reception of the two
satellites.
You can now watch the pre-programmed Astra 19.2 and Hot Bird channels.
Caution: Some monoblocs have a reverse command. It can be then necessary to
swap A and B in the DiSEqC line.
3
A
B
Ntc Accessbox-GB 3/11/03 8:44 Page 7