6
THIS FLUE KIT HAS BEEN MANUFACTURED IN
ACCORDANCE WITH AS/NZS 2918:2001.
TO ENSURE SAFETY THIS FLUE KIT MUST BE INSTALLED
AS OUTLINED IN THESE INSTRUCTIONS. THE APPLIANCE
TO WHICH IT IS CONNECTED MUST BE INSTALLED
IN ACCORDANCE WITH ITS MANUFACTURERS
SPECIFICATIONS AND AS/NZS 2918:2001.
• These installation instructions are for the Metro Ultra Insert
appliance only.
WARNING!
Important Information
• Mixing flue system components from different sources or modifying
the dimensional specification of components may result in hazardous
conditions. Where such action is considered, the manufacturer
should be consulted in the first Instance.
• It is the responsibility of the installer to ensure that the installation
of this flue kit complies with AS/NZS 2918:2001, the appliance
manufacturers specifications for flue pipe installation and that the
relevant building codes are adhered to.
• Bends and extensions to the length of a flue system are permitted
(AS/NZS 2918:2001 4.1)
CAUTION!
Important Information
Ultra Insert Flue Kit Installation Instructions & Component Checklist
(F)
(E)
(D)
(C)
(A)
(B)
(G)
Please read these instructions fully prior to installation of the Ultra Insert flue
kit and familiarise yourself with all the various components illustrated left and
listed below.
Note: Rivets, fire cement, chimney cap/flashing plate and masonry vent cover
are not included as they are supplied by the installer/home owner. Pioneer
manufacture a stainless steel masonry vent cover kit to complete installation.
Ultra Insert Flue Kit Components
(A) 1 x Stainless steel weather butterfly
(B) 1 x Stainless steel ECO Cowl top
(C) 1 x 420mm x 240mm diameter stainless steel ECO Cowl housing
(D) 1 x 480mm long stainless steel flue pipe extension with flashing cone
(E) 2 x 1200mm x 150mm diameter stainless steel flue pipe
(F) 1 x 600mm x 250mm diameter galvanised outer casing
(G) 1 x 1300mm x 150mm diameter stainless steel flue pipe (pre-fitted liner)
The Ultra Insert flue kit features a custom 1300mm length of 150mm diameter
flue pipe (G) with a pre-fitted stainless steel flue liner.
This section of lined flue must be fitted as close as possible to the Ultra Insert
firebox. If possible connect directly to the Ultra Insert flue spigot, but if it is
necessary to use a telescopic offset, then the section of lined flue must fit
directly above this component.
This flue kit has been manufactured and complies with AS/NZS2918:2001. To
ensure a safe and efficient installation, this flue kit must be installed as detailed
below by either a registered installer, or someone competent in installing solid
fuel appliances.
1. Check the masonry chimney for structural soundness and make any
repairs that are necessary.
Note: Most councils require the masonry chimney to be inspected prior to
installation. The masonry chimney cavity must also be swept prior to installation.
2. Once the fireplace insert has been installed correctly to the manufacturers
instructions, look directly down the chimney to ensure the firebox flue
spigot is in line with the masonry chimney. (A torch will be required).
3. If you cannot see the flue spigot, a flue pipe offset will be required. If so,
install the flue pipe offset so the top of it can be clearly seen from the top of
the masonry chimney.
Содержание Ultra Insert
Страница 16: ......