FLEXLINE ELECTRONIC PIN LOCK —
INSTRUCTIONS FOR USE
5
www.metro.com
L01-655
REV 01/20
Add User Without Specifying Memory Slot
The
Supervisor Code
memory location is called
Slot 01
and the first
User Code
is called
Slot 02
.
• Any additional user codes reside in memory slots 03-20.
• To add a user code without specifying a memory slot (03 -20), refer to
"RegulatoR Programming Mode"
to enter programming
mode.
User codes must be 4 to 8 digits in length and
must
be different from all existing codes (including Slot 01 Supervisor & Slot 02 User
codes).
NOTE:
There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1. Place RegulatoR into programming mode (See
"RegulatoR Programming Mode"
).
2. Press
"410"
and then press
ENTER
.
3. Type the new user code and press
ENTER
.
4. Retype the new user code and press
ENTER
.
5. If successful, the
yellow
indicator light will illuminate.
Continue programming or
press 9
and then
ENTER
to exit programming.
Add User to Specific Memory Slot (03 – 20)
The
Supervisor Code
memory location is called
Slot 01
and the first
User Code
is called
Slot 02
.
• Any additional user codes reside in memory slots 03-20.
• To add a user code to a specific memory slot (03 -20), refer
"RegulatoR Programming Mode"
to enter programming mode.
User codes must be 4 to 8 digits in length and
must
be different from all existing codes (including Slot 01 Supervisor & Slot 02 User
codes).
NOTE:
There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1. Place RegulatoR into programming mode (See
"RegulatoR Programming Mode"
).
2. Press
"411"
and then press
ENTER
.
3. Type memory slot to be added followed by
ENTER
(for memory slots 03 - 09, you must type leading “0” – e.g. “07” for slot 7).
4. Retype memory slot to be added followed by
ENTER.
5. Type the new user code and press
ENTER
.
6. Retype the new user code and press
ENTER
.
7. If successful, the
yellow
indicator light will illuminate.
Continue programming or
press 9
and then
ENTER
to exit programming.
Delete User Without Specifying Memory Slot
The
Supervisor Code
memory location is called
Slot 01
and the first
User Code
is called
Slot 02
.
• The additional user codes reside in memory slots 03-20.
• To delete a user code without specifying a memory slot (03 -20), refer
"RegulatoR Programming Mode"
to enter programming
mode.
NOTE:
There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1. Place RegulatoR into programming mode (See
"RegulatoR Programming Mode"
).
2. Press
"400"
and then press
ENTER
.
3. Type the user code to be deleted and press
ENTER
.
4. Retype the user code to be deleted and press
ENTER
.
5. If successful, the
yellow
indicator light will illuminate.
Continue programming or
press 9
and then
ENTER
to exit programming.
