Following start-ups
III - 12
Virtual digital oscilloscopes, 60 MHz
Following start-ups (continued)
Our
recommendations
(continued)
For Ethernet, make sure that:
•
the IP address in the configuration file is the same as the address
programmed in the oscilloscope: click on
and find your
instrument in the list of connected devices, or start-up the
instrument using USB; check the network parameters using the
Tools menu (see below).
•
the oscilloscope's IP address is not already used on the network
and does not cause an addressing conflict:
- disconnect the network cable from the oscilloscope, run a 'ping <IP
address>’ command from your DOS Command screen (menu
'Start/Run…’ and open 'cmd').
If an instrument responds, change the IP address.
- If the problem persists, close the SCOPEin@BOX_LE application,
disconnect it, then reconnect the power supply on the MTX 162 to
reinitialise it.
When the "READY” LED lights, re-launch the application.
Changing the IP
address
The IP address can be changed from the Tools
Network… menu in the
"Oscilloscope Control" window:
The
key gives access to the network mask and gateway
programming.
Once the new IP address has been entered click on
to validate it.
The address is then controlled before programming to make sure that the
entered address is compatible with the network and is not currently in use.
If the instrument is driven via Ethernet, the connection is stopped and
reinitialized using the new address settings.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
