Metra Electronics Tripod, Техническое руководство

Страница: 17 / 31

Page 17
Tripod Turnstile Technical Manual

Operating mode and Network address
After installation is complete, the device’s network addresses must be set by changing the Network
Address DIP Switch ( and ) pins positions.

NOTE

Each Metra device must have different address setting.
Switches
#1 and #2 are reserved for future use and must be set to OFF position (switch down).
Set switch
#3 on Master electronics board according devices hardware configuration:

OFF (switch down) indicates no Wristband Capturer is connected.

ON (switch up) indicates the Wristband Capturer is connected.
Set switch
#3 on Slave electronics board to OFF position (switch down).
Look up the code for desired Metra NET Network address in the coding table. Set switches
#4
through #8 to indicated positions, where:

0 indicates the corresponding switch is in OFF position (switch down).

1 indicates the corresponding switch is in ON position (switch up).
Coding table:
switch positions Master
address
Slave
address
switch positions Master
address
Slave
address
4 5 6 7 8 4 5 6 7 8
0 0 0 0 0 300 332 1 0 0 0 0 316 348
0 0 0 0 1 301 333 1 0 0 0 1 317 349
0 0 0 1 0 302 334 1 0 0 1 0 318 350
0 0 0 1 1 303 335 1 0 0 1 1 319 351
0 0 1 0 0 304 336 1 0 1 0 0 320 352
0 0 1 0 1 305 337 1 0 1 0 1 321 353
0 0 1 1 0 306 338 1 0 1 1 0 322 354
0 0 1 1 1 307 339 1 0 1 1 1 323 355
0 1 0 0 0 308 340 1 1 0 0 0 324 356
0 1 0 0 1 309 341 1 1 0 0 1 325 357
0 1 0 1 0 310 342 1 1 0 1 0 326 358
0 1 0 1 1 311 343 1 1 0 1 1 327 359
0 1 1 0 0 312 344 1 1 1 0 0 328 360
0 1 1 0 1 313 345 1 1 1 0 1 329 361
0 1 1 1 0 314 346 1 1 1 1 0 330 362
0 1 1 1 1 315 347 1 1 1 1 1 331 363

Power-ON
To power button is situated on the connection board.