Page 16
Tripod Turnstile Technical Manual
DIP switch settings
#
description
1
Parameters request button - Slave
2
Network Address DIP switch - Slave
3
Parameters request button - Master
4
Operating Mode/Network Address DIP switch - Master
By changing the Network Address DIP Switch (
and
) pins positions, different network
addresses can be set. To change between different pins positions, use a small flat headed
screwdriver or similar object to push DIP switch pins to desired position.
After each settings change or after device’s first installation power off and back on the device (for the
new settings to take effect) and obtain operating parameters if the device is connected to Metra NET
Network controlled by Metra Network Controller and Metra SW.
Operating parameters are obtained through the Metra NET Network. The server must be set up and
running for that purpose. To obtain operating parameters, press the PARAMETERS REQUEST buttons
(
and
) on Master and on Slave electronics board.
