1.
Remove the ashtray and (2) screws from the
ashtray location. (Figure A)
2.
Remove (1) screw below and (2) screws above the
steering column. (Figure A)
3.
Pry the A/C vents out and remove the screws
exposed in the vent cavities.
4.
Remove (6) screws from the edge of the dash trim
bezel and remove the bezel. (Figure A)
5.
Remove the hardware securing the factory mounting
brackets to the factory radio. (Figure B)
6.
Remove and retain the brackets.
Oldsmobile Cutlass Ciera
1982-1996
Oldsmobile Omega
1983-1984
Oldsmobile Cutlass
Supreme 1984-1988
1.
Remove the radio trim bezel, and then disconnect
the cigarette lighter connector. (Figure A)
2.
Remove the hardware securing the factory
mounting brackets to the factory radio.
(Figure B)
3.
Remove and retain the brackets.
1.
Remove (4) hex-head washer screws from the
steering column trim panel, pull down on the rear
edge of the panel and remove.
2.
Remove (4) Phillips screws from the top edge of
the dash trim bezel. (Figure A)
3.
Remove (2) hex-head washer screws from
the bottom of the dash trim bezel and remove
the bezel. (Figure A)
4.
Cut and remove all mounting tabs on Bracket #2
EXCEPT tabs “C”.
Note:
Identify mounting tabs by the stamped letter
on the back of each tab.
(Figure A)
(Figure B)
(S-10 application
shown as example)
(Figure A)
(Figure B)
(S-10 application
shown as example)
(Figure A)
(Figure B)
“C”
“C”
“C”
“C”
Dash Disassembly 99-4644
