Metos Kodiak 30 VL-1C, Руководство пользователя

Страница: 3 / 16

3
t
ransport
:
Lifting equipment should always be used to move the machine. Allowance should be made for the fact that
the machine is ‘top-heavy’.
The machine must not be pulled or lifted by the bowl lift handle.
When the machine is moved, it should be in a vertical position at all times.
i
nstallation and fixinG
:
The ambient temperature around the machine must not exceed 45 o C.
When the mixer is delivered, the adjustable feet will be turned right to the
bottom.
The height of the legs should be adjusted so that the bowl on
the bowl trolley fits perfectly into the bowl arms.
The bowl arms should be at the correct height above the floor before
the machine is taken into use – see Adjustments, page 6 .
The legs of the mixer are adjustable and can be adjusted by turning them individu-
ally. See
Adjustments, page 6.
The mixer is fixed in place using the fittings that come supplied:
• The mixer should be fixed to the floor if it is installed on board a ship.
• The mixer should be fixed to the floor if the hook tool is used at speeds
above setting 3 (recommended maximum speed with hook).
Electrical connection:
Users can connect the mixer to the power supply themselves; refer to the section on
Electrical connection
which must be
followed.
For the benefit of service staff, it should be clear to see when the mains plug to the mixer has been removed from the
socket in the wall.
The cable is fixed to the machine on the mains board with a wire loop.
Before the machine is connected to the mains, check that the voltage and frequency printed on the name plate
are correct for the installation location. The name plate is positioned uppermost on the back of the machine.
There is a risk of injury if the machine is not earthed.
It must be ensured that the cable used to connect the machine to the mains meets the standard for the country
in which the machine is installed. See also
Example electrical connections, page 13
The mixer must be earthed. Failure to do so may cause injury
. If there is no earth connection, the EMC
filter will not work, with the risk of damage to the frequency converter.
When the machine is connected, phase + n earth or phase + phase + earth should be used. In
both cases, it is important to ensure that the voltage between the two live pins matches the name plate. (See
examples on page 13)
The machine must only be connected to an earthed mains supply.
A plug with two pins plus earth should be used. Alternatively, two wires plus earth from a three-phase supply
may be used.
The machine should be protected by a differential switch.
The machine is protected by a 10A fuse. The fuse is built into the socket on the back of the machine.
Tighten the M8 pointed screw
after installation.
Use M10 screws that are suitable
for the floor material.
2 pieces washer M10