1
LIMITED WARRANTY AND LIMITATION OF LIABILITY
Your Meterman product will be free from defects in material and workmanship for 90 days from the date
of purchase. This warranty does not cover fuses, disposable batteries or damage from accident, neglect,
misuse, alteration, contamination, or abnormal conditions of operation or handling. Resellers are not
authorized to extend any other warranty on Fluke’s behalf. To obtain service during the warranty period,
return the product with proof of purchase to an authorized Meterman Test Tools Service Center or to a
Meterman dealer or distributor. See Repair Section above for details. THIS WARRANTY IS YOUR ONLY
REMEDY. ALL OTHER WARRANTIES –WHETHER EXPRESS, IMPLIED OR STATUTORY -
INCLUDING IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR
MERCHANTABILITY, ARE HEREBY DISCLAIMED. MANUFACTURER SHALL NOT BE LIABLE FOR
ANY SPECIAL, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES OR LOSSES, ARISING
FROM ANY CAUSE OR THEORY. Since some states or countries do not allow the exclusion or limitation
of an implied warranty or of incidental or consequential damages, this limitation of liability may not apply
to you.
CERTIFICATIONS AND PRECAUTIONS
This instrument is EN61010-1 certified for Installation Category I -1000V; Pollution Degree II, Class 2. It
may only be used to make measurements on energy limited circuits within equipment. All inputs are
protected against continuous overload conditions up to the limits of each function's stated input protection
(see specifications). Never exceed these limits or the ratings marked on the instrument itself. Always
inspect your Multimeter, test leads and accessories for signs of damage or abnormality before every use.
If an abnormal condition exists (broken or damaged test leads, cracked case, display not reading, etc.),
do not use. Never ground yourself when taking measurements. Do not touch exposed metal pipes,
outlets, fixtures, etc., which might be at ground potential. Keep your body isolated from ground and never
touch exposed wiring, connections, test probe tips, or any live circuit conductors. Do not operate
instrument in an explosive atmosphere (flammable gases, fumes, vapor, dust.) Do not use this or any
piece of test equipment without proper training.
Symbols Used in this Manual
W
Refer to the manual
B
Alternating Current
X
Dangerous voltage
F
Direct Current
T
Double Insulation
P
Complies with EU
directives
J
Earth Ground
G
Diode
This instrument is shipped configured for 230 volt operation. Operation at 117 VAC requires that the fuse
be changed and the proper power cord used.
This meter is shipped with two power cords. The 117/230
volts power switch on the rear panel has been set to 230
volts and the 0.08A fuse installed.
Please verify the switch and fuse for your location
before installing the power cord
To change to 117 V operation, install proper fuse at
back panel (see manual) and set switch to 117V.
installing the power cord
This meter is shipped with two
