19
MAINTENANCE
Changing Input Power Configuration
This meter was shipped with power cords and fuses for 117V (USA) and 230V (European) operation.
The initial configuration is for 230V.
Fuse Replacement
This DMM has two fuses. The main power fuse is 0.08A or 0.125A, 250V for line protection. The current
measurement fuse is 2A / 250V for below 2A current measurements (unscrew the mA – 2A input jack).
117 Line Fuse
T 0.125A / 250V Bussmann GDB-125mA
Littel Fuse 218.125
230V Line Fuse
T 0.08A / 250V
Bussmann GDB-80mA
Littel Fuse 218.080
2A Current Input Fuse F 2A / 250V
Bussmann GMA-2A
Littel Fuse 216.002
MAINTENANCE
If there appears to be a malfunction during the operation of the Multimeter, the following steps should be
performed in order to isolate the cause of the problem:
•
Review the operating instructions for possible
mistakes in operating procedure.
•
Inspect and test the Test Cables for a broken or intermittent
connection.
•
Inspect and test the fuse. See Fuse Replacement.
CLEANING
CAUTION
DO NOT USE AROMATIC HYDROCARBONS OR CHLORINATED SOLVENTS FOR CLEANING.
THESE SOLUTIONS WILL REACT WITH THE PLASTIC MATERIALS USED IN THE INSTRUMENT.
Clean the front panel and case with a mild solution of detergent and water. Clean dust from the circuit
board with clean, dry, low pressure air (20 psi or less). Contaminants can be removed from the pcb using
demineralized water and a soft brush (remove the display assembly before washing the Main PCB and
avoid getting excess amounts of water on the switches). Dry with clean, dry, low pressure air and then
bake at 50 to 60°C (122 to 140°F) for 24 hours.
REPAIR
All test tools returned for warranty or non-warranty repair or for calibration should be accompanied by the
following: your name, company’s name, address, telephone number, and proof of purchase. Additionally,
please include a brief description of the problem or the service requested and include the test leads with
the meter. Non-warranty repair or replacement charges should be remitted in the form of a check, a
money order, credit card with expiration date, or a purchase order made payable to Meterman Test Tools.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement that follows, and check your batteries and fuses before requesting
repair. During the warranty period any defective test tool can be returned to your Meterman Test Tools
distributor for an exchange for the same or like product. Please check the “Where to Buy” section on
www.metermantesttools.com for a list of distributors near you. Additionally, in the United States and
Canada In-Warranty repair and replacement units can also be sent to a Meterman Test Tools Service
Center (see below for address).
