Metek MX15, Руководство по установке

Страница: 25 / 33

Installation Manual - Rev C California Instruments
MX15 Series 21
2.7 Connectors - Rear Panel
A number of connectors are located along the top rear covers. These connectors are in a
recessed area to protect them from shipment damage.
2.7.1 System Interface
WARNING: The system interface connectors are for use with California Instruments
supplied cables, and only between California Instruments equipment.
The Clock and Lock BNC connectors located on the rear panel are used to synchronize and
control the phase shift between the three outputs when 2 or 3 units are operating as a clock and
lock system. This mode of operation requires the -LKM (on Master unit) and -LKS (on Auxiliary
units) options. See paragraph 2.9 for more information on this mode of operation.
A set of two identical System Interface connectors, P8 and P9 is located on the rear panel of
each MX15 chassis. The system interface is used to connect the multiple MX15 power sources in
a Master/Auxiliary configuration to create MX30/2 and MX45/3 models. In these configurations,
only the Master MX15 power source has a built-in controller and front panel.
Table 2-3: System Interface Connectors
P8 / P9 Description
1 OUTP: Output ON. Controls state of output relay
2 N/C
3 N/C
4 N/C
5 COM: Common. Signal return.
6 OT: Over temperature. Indicates over temperature condition.
7 N/C
8 CLB: Current Limit B. (Not Used)
9 CSA: Current Sum Phase A
10 CSC: Current Sum Phase C (Not Used)
11 FLT A: Amplifier Fault Phase A
12 FLT C: Amplifier Fault Phase C (Not Used)
13 XFMR: Optional voltage range select. (-HV or -XV option)
14 PARALLEL: Parallel operation control. (Not Used)
15 INPUT ON: Input power status
16 A ERR LO: Error Signal Phase A, low
17 B ERR HI: Error Signal Phase B, high (Not Used)
18 N/C
19 C ERR LO: Error Signal Phase C, Low (Not Used)