17
OPERATION MANUAL
Machine setup-
First ensure that the machine is level and all four levelling jacking bolts are
correctly adjusted. Ensure the rear fences are tight and the stabilizing bolt is on the ground to
stop the fence moving around.
Alignment-
The sensors are sensitive to alignment so try to align as accurately as possible. If
the sender is only slightly aligned with the receiver any vibration when cutting will stop the
pump and the safety circuit will have to be reset again. Alignment could involve loosening the
sensor mounting screws or bending the mounting brackets to get the best alignment
Identifying sensors
Senders- Each sender has a red light on top of the unit
and a red light on the front. These two lights will be on
all the time while the machine has power.
4.2 SAFETY SENSOR ALIGNMENT CONT.
22/07/2019
Instructions Manual for SG-420 (S535)
17
