11
OPERATION MANUAL
3.2 MACHINE LEVELING
To set your machine up so that it operates to optimum performance, apply the following level-
ing procedure
After your guillotine has been anchored to a concrete slab floor, it then needs to be leveled. The
leveling is performed using the screws on each pad.(Fig. 3.1). Loosen the hold down bolts and
place a level on the surface of the working table. Tolerances: 1000:0.30mm, for both longitudi-
nal and transverse.
Metal plates need to be placed under each jacking screw to distribute the load. Once level then
tighten the hold down bolts.
The machine must not rest on supports
other than those defined in Fig. 3.1
q
Bolt the support arms onto the feed table. Ensure they are level and square to the table.
(Fig.3.2)
F
ig
.3.2
3.3 ATTACHING THE ACCESSORIES.
F
ig
.3.1
Jacking Screw
Metal Plate
22/07/2019
Instructions Manual for SG-420 (S535)
11
