10
TBS-Series | Version 1.03
Operation
8
Operation
Step 1: Place the sheet to be cut on the machine table,
bring the scale into the correct position and ad
-
just the material stops to the desired size.
Step 2: Press the sheet against the material stops and fix
it with the hold-down by moving the hand lever
downwards a little.
Step 3: Move the hand lever completely down to make
the cut.
9
Care and Maintenance
9.1 Care by cleaning
Clean the sheet metal shears regularly with a soft, damp
cloth. Treat bare metallic work surfaces with anti-rust
spray. Never use solvents to clean plastic parts or pain
-
ted surfaces. A surface release and consequential da
-
mage may occur.
9.2 Lubrication schedule
Fig. 11: Grease nipple for hand lever
All moving parts of the metal shears must be lubricated
regularly.
WARNING!
Danger due to insufficient qualification of
persons!
Insufficiently qualified persons can not assess the
risks involved in handling sheet metal shears and
expose themselves and others to the risk of serious
or fatal injuries.
- All work should only be carried out by qualified per
-
sons.
- Keep inadequately qualified persons out of the work
area.
ATTENTION!
Risk of crushing!
Incorrect work on the sheet metal scissors is a risk of
injury to the upper limbs.
DANGER!
The following rules must be followed.
- Never work on the sheet metal scissors under the
influence of alcohol, drugs or medication and / or in
case of fatigue or concentration-impairing illnesses.
- The sheet metal shears may only be operated by a
trained person.
Use protective gloves!
Use protective boots!
Wear protective clothes!
Tips and recommendations
To ensure that the sheet metal shears are always in
good operating condition, regular care and main
-
tenance work must be carried out.
WARNING!
Danger due to insufficient qualification of
persons!
Insufficiently qualified persons can not assess the
risks involved in handling sheet metal shears and
expose themselves and others to the risk of serious
or fatal injuries.
- All work should only be carried out by qualified per
-
sons.
NOTE!
After servicing, maintenance and repair, check that all
panels and guards are correctly installed on the ma
-
chine and that there are no tools inside or in the wor
-
king area of the sheet metal shears.
Damaged protective devices and parts of the device
must be repaired or replaced as agreed by a recogni
-
zed specialist workshop.
