Metaflex MDA120, Руководство по установке

Страница: 34 / 55

Installers manual 10.03.02-R03 (201058) EN SDA-04 (SW 5.xx) - SDA-04DCB2 (SW 22.00)
P
age 34 of 55
9 Display codes and troubleshooting
Nr Display 5.xx Display 4.06 Omschrijving
*... 1
e
point blinks 2
e
point blinks Setup on 90 Watt AC motor
.*.. 2
e
point blinks 3
e
point blinks Setup on 370 Watt AC motor
..*. 3
e
point blinks - Setup on 370 Watt AC motor heavy reductor
…. …. ….
Idle (DCA/DCB)
- bo bo Boost, extra force after closing
- 1 1 Security 1 active (safety edge)
- 2 2 Security 2 active (fotocell 1)
- 3 3 Security 3 active (fotocell 2)
Lo Lo Lo Lock fault, no feedback
- ONE- 1d One way active
- o1 o1 Obstruction in indentation
- o2 o2 Obstruction during opening
- o3 o3 Obstruction during closing
- oc oc DMS activated
FF Fire FF Fire cycle activated
ES Stop ES Emergency stop activated
UL unLo uL Emergency open activated
- Edge E Edge control active: always slow
- LL LL Initialisation process pending
- Fo Fo Input open outside activated
- Ho Ho Input half open outside activated
- Fi Fi Input open inside activated
- Hi Hi Input half open inside activated
- iLoc iL Input lock activated
- PS 1 - Safety sensor 1 activated
- PS 2 - Safety sensor 2 activated
- PS 3 - Safety sensor 3 activated
- PS 4 - Safety sensor 4 activated
- iLF1 - Interlock disable functie 1 activated
- iLF2 - Interlock disable functie 2 activated
- iLF3 - Interlock disable functie 3 activated
- iLF4 Interlock disable functie 4 activated
1 E 01 (AC)
Batt (DCB) E 01 (AC)
Batt (DCB) Undervoltage
Accu nearly empty
2 E 02 (AC) E 02 (AC) Overvoltage
3 E 03 E 03 Overcurrent or shortcircuit to ground (after
power on)
4 E 04 (AC) E 04 (AC) IxT monitoring motor
4 E RE (DCB) E RE (DCB) Reversed motor polarity
5 E 05 (AC) E 05 (AC) IxT monitoring inverter
6 E 06 (AC) E 06 (AC) Motor temperature too high
7 E 07 (AC) E 07 (AC) Inverter temperature too high
8 E 08 E 08 EEPROM failure or not initialized
9 E 09 E 09 Belt broken, position out of normal range
10 E 10 E 10 Initialize failed
11 E 11 E 11 Position encoder fault
12 E 12 E 12 Monitoring check photocell failed
13 E 13 (AC) E 13 (AC) Motor type failed: measured coil resistance not
matching
14 E 14 (AC) E 14 (AC) Inverter temperature high warning
15 E 15 - Accu fault (no accu or reversed polarity)