Metaflex MDA120, Руководство по установке

Страница: 22 / 55

Installers manual 10.03.02-R03 (201058) EN SDA-04 (SW 5.xx) - SDA-04DCB2 (SW 22.00)
P
age 22 of 55
7.3.2 Setting up safety devices
Parameter 40 : (0) Setting the controller to Industrial or EN16005 use

0 = “legacy mode” the software will behave as if it were up to version 4.06
Safety devices will not be monitored

1 = Safety devices are monitored in accordance with EN16005
(Relay 1 is reserved exclusively for monitoring the safety devices)
If parameter 40 is set to 1:
One can connect up to 4 monitored (EN16005) safety devices:
Input 29 (PS1) : Non track side
Input 32 (PS2) : Track side
Input 25 (PS3) : Track side (additional sensor in case of an extra wide door)
Input 26 (PS4) : Sliding space
When conforming to the EN16005 it is mandatory to connect, at a minimum,
Two EN16005 safety devices. See relevant appendix for connection diagrams.
Parameter 41 : (0) “Personal Safety 1” (message “PS1” in EN16005 mode)
(input 29) “Photocell 1” (message “2” in Legacy mode)

0 = Only active while closing (interrupting the signal opens the door)

1 = When the door is closed, the sensor will also work as an opener
(any interruption of the signal will open the door)
Parameter 42 :
(0) “Personal Safety 2” (message “PS3” in EN16005 mode)
(input 32) “Photocell 2” (message “3” in Legacy mode)

0 = Only active while closing (interrupting the signal opens the door)

1 = When the door is closed, the sensor will also work as an opener
(any interruption of the signal will open the door)

2 = Only active while opening (interrupting the signal closes the door)
Both sensor inputs (29 and 32) are suitable for normally open (N.O. /NPN) or
normally closed (N.C. /PNP) contacts from external sensors such as photo,
infrared or radar detectors. The inputs are configured as normally closed (N.C.)
and optionally drawn from ground (0VDC) or the positive voltage (24VDC). When
an input is not used, it must be connected to 0VDC or 24VDC.
In case the sliding space sensor is activated (Parameter 43 or 44) the door will
open and hold 20cm prior to the end position. On de-activation of the sensor the
door will resume it’s travel to the full open position.
Parameter 43 : (0) “Personal Safety 3” (message PS3) only present in EN16005 mode
(input 25)

0 = Only active while closing (interrupting the signal opens the door)

1 = Only active while opening (interrupting the signal closes the door)