Meta System GPA600, Инструкция по установке и программированию

Страница: 7 / 20

Activate Instal.
password ?
Installer OK
Select function:
BLOCKED level
UNBLOCKED level (User)
UNBLOCK FUNCTIONS level (Owner)
INSTALLER level
NB
The initial display may show “ACCESS DENIED…. INSERT CODE” instead of “DEACTIVATED …..(IN MAINTENANCE)”: this
appears when the module is no longer being maintained!
deactivated
(in maintenance)
GPA800 OK
In maintenance
Activate Funct.
password?
Functions active
Select function:
0
0
OK
OK
OK
OK
0
OK
11111
33333
OK 44444
PROGRAMMING MENUS
From INSTALLER level, it is possible to display all the menus required for the configuration of the product.
It is possible to scroll through the various menus using the (
▲ ▼
) arrow keys.
For a more rapid display of each menu, it is possible to enter the relative quick command directly followed by OK (the
quick commands are shown in the boxes next to the menus).
Installer OK
Select function :
Check
GSM Status?
SIGNAL GSM 50%
= = = = =
CHECK GSM STATUS 365
•Warning: if the device realises that the SIM requires unblocking when the
menu is accessed, the PIN must be entered to release it. In this case,
press the + key and key in the PIN when the relevant screen appears, then
confirm by means of the OK key.
•
This menu confirms the quality of the current GSM signal and is shown
both as a percentage and in a chart format.
• Other information provided:
NO GSM = this means that no GSM signal has been captured. Possible
causes: Incorrect connection of the aerial or failure of internal GSM module.
GSM module in low power mode = this means that the GSM is in low
consumption mode. The ignition key is probably switched off .
GSM signal too low = the signal must be at least 20%. Take the vehicle
outside; check the connection of the GSM aerial; check the cables; change
the place where the GSM aerial is installed; the signal from the telephone
service provider may be weak.
GSM module status Undefined
GSM module not answering..
Error SIM card not found:
Should one of the above messages appear, exit the menu and enter 999;
press OK and wait …. The device will reset after a few seconds. Try again 2
or 3 times; if the problems persist, contact our Help Desk
Done
OK
OK
MODES OF ACCESS TO THE VARIOUS LEVELS
7