Meta System GPA600, Инструкция по установке и программированию

Страница: 16 / 20

HIDDEN MENUS CALLED UP BY QUICK COMMANDS
The menus shown below can only be called up by using the quick commands. These menus are not usually displayed
because they should not be needed for standard installation purposes. They are, therefore, “hidden“ and can be called up
should this be necessary. In order to display them, enter INSTALLER Level, enter the relevant quick command and press OK.
The menu will be concealed once again after you have exited it.
This is the serial number of the internal GSM module.
It always differs from product to product (the number shown
opposite is by way of example!)
This is the version of the internal GSM module’s software.
This menu is used to verify its update status.
(the number shown opposite is by way of example!)
If you press OK, you can ask the device to provide
information concerning the remaining credit in the credit for
unit SIM card.
This menu is used to modify the number of units for the
transmission of the low credit warning message, placed by
the LOW CREDIT calls list. It is possible to set a minimum of
10 units and a maximum of 1000 units.
This menu is used for the configuration of the format for the
display of the GPS coordinates. In addition to
DEGREE.MIN.SEC, it is possible to set DECIMAL or NMEA
formats. Use the
+ and – keys to select the format and the
OK key to confirm the modification or the C key to exit
without storing it.
This menu is used to modify the filter for the ignition key
signal. This parameter makes it possible to compensate for
any disturbance on the signal. It is possible to programme
from 0 to 254 units and each unit corresponds to 16ms. A
higher number corresponds to a greater filter.
This menu is used to modify the filter for the alarm VOL1
signal. This parameter makes it possible to compensate for
any disturbance on the signal. It is possible to programme
from 0 to 254 units and each unit corresponds to 16ms. A
higher number corresponds to a greater filter.
This menu is used to modify how much time must pass
before the ignition will be immobilised by means of a remote
command via SMS after the ignition key has been switched
off. The default factory setting is 15 sec, but it can be
programmed from 0 to 60 sec.
208
209
371
384
502
503
424
367
DISPLAY WHAT IT MEANS
QUICK
COMMAND
16
IMEI Code
520338422519442
GSM mode SW Rel.
REVISION 04.00
Check
GSM credit?
Credit warning
at 50 units
co-ordinate mode:
DEGREE.MIN.SEC
Anticarjack:
KeyLock 15sec
Stimuli filter
value 10
VOL1 filter
value 10