Meta System GPA600, Инструкция по установке и программированию

Страница: 5 / 20

- The steps described below must be followed after all the cabling on the vehicle has been completed according to the
enclosed installation manual.
- Unblock the SIM card after it has been switched on by keying in the release PIN number if necessary.
- Connect a Sat Programmer as described in the following pages.
- Enter INSTALLER level and complete the steps for configuration by following the instructions given in the descriptions of
the menus.
Important:
The GPA terminal enables SMS and voice communications using GSM technology. Therefore a SIM card is required (not
supplied by MetaSystem) for it to function correctly. MetaSystem recommends the exclusive use of contract-based SIM
cards to ensure optimum operation of the product.
Complete programming according to the steps described below to safeguard correct installation
CONFIGURATION PROCEDURE
CHECKING AND CONFIGURATION FOR INSTALLATION
CUSTOMISATION
❒
Check the GSM signal (enter PIN if requested)
❒
Complete the SIM initialisation procedure (this is a very important step and must be carried out before any other
programming!)
❒
Complete the battery check
❒
Check the GPS signal (only for GPA 800) *
❒
Switch on the menu for the hands free kit *
❒
Complete programming of the polarity of the vehicle’s alarm signal (VOL1) (if necessary)
❒
Complete programming of the maximum number of alarms for VOL1
❒
Complete programming of the immunity against external alarms
❒
Complete programming of the delay before starting GSM calls
❒
Check the inputs in the “Display I/O” menu; the inputs are:
❍
Ignition signal
❍
VOL1 signal (vehicle alarm)
❍
Crash Sensor *
❒
Check the ignition immobilisation is working by disconnecting a faston connector (only for GPA 800).
NB: please remember that remote ignition immobilisation via SMS is activated 15 seconds after the ignition key has
been switched off. This parameter can be modified, if necessary, by means of a “hidden” menu.
❒
Complete calibration of the tachometer
When the above has been completed correctly, the device can be installed permanently and any parts that were taken off
the vehicle can now be replaced.
Complete any customisation of the device using the “Questionnaire for the vehicle’s owner”
❒
Complete programming of the phonebook
❒
Complete programming of the ring tones *
❒
Complete programming of the volume of the ring tones *
❒
Enter the vehicle’s number plate
❒
Complete programming of the calls lists (we recommend programming the CAR ALARM list first as configuration is
always necessary if present and connected to an external alarm).
❍
CAR ALARM (must always be set)
❍
AID REQUEST * (only if inertia switch or crash sensor installed)
❍
BATTERY ALARM (only if required)
❍
SPEED WARNING (if odometer present)
❍
LOW BATTERY (only if required)
❍
LOW CREDIT (only for Sim card with credit for unit)
❍
PERIODIC (only if required)
❒
Complete programming of privacy mode as per requirements
❒
Set the telephone for incoming calls only / outgoing calls possible as per requirements *
❒
Set vitality transmission (the default setting is ‘not active’)
❒
Set the speed limit
* = Requires use of an OPTIONAL device (only if present)
5