034E-9800 REV A
Page 18
4.4
Wind Speed Reed Switch Cartridge Replacement
A.
Follow Steps A through H in Section 4-2.
B.
Open the sensor housing.
C.
From the terminal block circuit board, disconnect the black and red wires coming
from the Reed Switch Cartridge (item 15) from locations J1-1 and J1-2.
D.
Push switch cartridge out of its seat. Clean off any old sealant from the Top Plate
Assembly.
E.
Refer to Figure 4-6. Apply a small bead of RTV silicone sealant under cartridge
flange. Noting proper orientation, push into hole.
F.
Wipe away excess sealant. Allow for overnight curing before reassembly.
G.
Using care to avoid stressing switch leads while routing, connect the switch wires
in the terminal strip. Match wire colors with sensor connector harness. Refer to
Figure 4-2.
H.
Follow steps J through O in Section 4.2.
Содержание 034E
Страница 2: ...034E 9800 REV A Page 2 ...
Страница 20: ...034E 9800 REV A Page 20 FIGURE 4 7 EXPLODED PARTS VIEW OF 034E ...
