37
Firmware
The information about the camera are explicitly written under this page. Also, users can manually update System Firmware if
available. All motions of camera will be stopped during the firmware update. Please close any other screens before firmware
update. Never disconnect power or LAN cable during the updating process. It takes approximately 3 minutes for the unit
to reboot after firmware update process. Again, power can’t be lost when updating firmware since it will cause the update
failure and manufacturer maintenance will be therefore required. Click “Browse” to locate a corresponding firmware file and
click “Upgrade” to proceed.
Figure 4 - 24: Firmware Settings
Initialize
Figure 4 - 25: Initialize Settings
●
Camera Type
Select “NTSC” or “PAL” in accordance with different requirements. Flickering by fluorescent light can be reduced by
selecting “PAL” for the power frequency 50Hz or “NTSC” for the power frequency 60Hz
●
Import Setting
Press “Browse” to locate a file and then click “Import” to upload configuration settings from local to the camera.
●
Export Setting
Press “Export” to download configuration settings to local computer.
●
Reboot
Press “Reboot” to simply reboot the camera.
●
Software Factory Default
Press it to reset all configuration settings back to factory defaults excluding network settings.
●
Hardware Factory Default
Press it to reset all configuration settings back to factory defaults.