![background image](http://html1.mh-extra.com/html/messoa/ncr373/ncr373_user-manual_1775563030.webp)
29
•
Primary DNS: Same as the above.
•
Secondary DNS: Same as the above.
•
IPv6 Enable: Check the box to enable IPv6 protocol.
•
Accept IPv6 router advertisements: Check the box to activate RA (Router Advertisement) corresponding to RS (Router
Solicitation) for IPv6 address designation.
•
Enable DHCPv6: If enabled, the camera will automatically obtain an available dynamic IP address under IPv6 protocol from
the DHCP server each time it connects to the LAN.
•
IPv6 Address: To manually set an IP address under IPv6 protocol.
•
Subnet prefix length: Set prefix length for subnet ranging from 1 – 128.
•
IPv6 default router address: To manually set a default router address under IPv6 protocol.
•
Subnet prefix length: Set prefix length for subnet ranging from 1 – 128.
•
IPv6 DNS: Set a DNS (Domain Name Server) under IPv6 protocol.
●
Wire Setting
•
Speed & Duplex: Due to the attribute of collision, Half Duplex can only send or receive information at one time, while Full
Duplex is able to receive and transmit in full line rate simultaneously without the issue of collision. For the number to Mbps,
larger the number, faster it results in; smaller the number, on the other hand, slower it brings about. “Auto” simply lets the
camera to decide which mode to adopt.
●
UPnP
•
Enable UPnP: When UPnP (Universal Plug & Play) is set to “ON”, the unit can be detected automatically by any computer in
the LAN to skip the installation of the IP Finder utility.
•
Mode: When the camera connects with the LAN, select one of the modes below for identification:
»
IP and Device Name: The device name and IP address will be shown synchronously.
»
Device Name: Only device name will be shown.
»
User Input: User can input a friendly customized name for the camera.
●
SSL
•
Enable SSL: Turn Secure Sockets Layer (SSL) ON to enable communication security mechanism over internet network.
Note
Please click “Save” button to save your settings.
FTP Server
Figure 4 - 13: FTP Settings
●
Enable
Simply click “ON” to activate the FTP server function or “OFF” to disable it.
To log on the FTP, simply enter ftp://<Login ID>:<Password>@<ip address> in the location field of Microsoft’s Internet
Explorer and the recordings will be shown up. The default setting, for example, is ftp://admin:[email protected]. The
maximum connection for FTP server is up to 30.
Note
Please click “Save” button to save your settings.