MeshLinx MWI-5000, Руководство пользователя

Страница: 24 / 94

MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
2
start autoconfig
To stop and disable
Autoconfig / LnL when Autoconfig / LnL is running
stop autoconfig
set autoconfig disable
4.2.3.17 HTTP Server
get http – get all HTTP parameters
get http wlanaccess – display Ethernet access
get http ethaccess – display Ethernet access
get http port – display port number
set http [enable | disable] – set HTTP state
set http port <int> - set port number
Note: WEP is enabled when either
open enencryp
or
share enencryp
is set;
disabled when both
open disencryp
and
share disencryp
are set.
4.2.3.18 Security
This section lists CLI commands used to display and configure the
MWI-5000 security features.
The following commands display and modify the global security
settings for the AP.
set ap security [legacy-clear|legacy-encrypt|wpa|wpa2|wpa+wpa2|tsn]
Sets the global security mode for the AP. The following table
shows the type of wireless stations allowed to associate for
each security mode.
get ap security - Displays the selected security mode.
The following commands are used to display and modify security
settings when the MWI-1500 System is configured for legacy-encrypt
mode.
set ap keylength [64|128] – Sets static WEP key length (64-bit or
128-bit).
get ap keylength - Displays the static WEP key length.
get ap keyselect - Displays the static WEP key index used for
encrypting packets prior to transmission.
The following commands are used to display and modify security
settings when the MWI-1500 System is configured for the wpa, wpa2,
wpa+wpa2, or tsn security modes.
get ap wpa -
display the WPA security configuration.