MeshLinx MWI-5000, Руководство пользователя

Страница: 15 / 94

MeshLinx MWI-5000 User Guide
MESHLINX CONFIDENTIAL
1
4.2.3.7 Bootconfig
get bootconfig – Display the boot configuration file for next
boot.
set bootconfig <cfg_filename> - Select the configuration file
used to boot the MWI-5000 System. The change takes effect on
the next system boot.
4.2.3.8 Start
start [ap | eth | wif<1|2|3|*> | tcpip | dhcp | http |
autoconfig | radius | snmp | dfs ]
4.2.3.9 Stop
stop [ap | eth | wif<1|2|3|*> | tcpip | dhcp | http |
autoconfig | radius | snmp | dfs]
4.2.3.10 Reset
reset - this command resets the AP system.
4.2.3.11 WIF (WLAN Interface)
get wif* - Get all sectors status.
get wif<1|2|3> opmode – Get operating mode of the wireless
interface
get wif<1|2|3> channel - Get channel number and AICS.
get wif<1|2|3> maxrate - Get sector max rate.
get wif<1|2|3> basicrate – Get sector basic rate setting.
get wif<1|2|3> sensitivity – get sector RX sensitivity.
get wif<1|2|3> rts – Get RTS setting (enabled/disabled).
get wif<1|2|3> cts – Get self-CTS setting (enabled/disabled)
get wif<1|2|3> frag - Get frag
get wif<1|2|3> txpower – Get Tx power and ATPC.
get wif<1|2|3> beacon - Get beacon interval.
get wif<1|2|3> header - Get header type.
get wif<1|2|3> mode – displays operating mode 11G, 11A, 11BG
or 11B.
get wif<1|2|3> diversity
–
displays antenna diversity.
get wif<1|2|3> dpd – displays Digital Pre-Distortion
configuration of sector baseband.
Set wif X sets the specified parameter for the sector number used for X , where X is
1-3. The selected parameter is set for all WIFs if wif* is used with this command.