Merope-dive-tools Compass K22 DPV
7
2.3.2 Reset dive timer
:
If required, the dive timer can be reset. After the reset this timer will be set to 000.00 minutes.
The dive timer will count the number of minutes and will show, for example, 075:12. This means
that you have dived for 75 minutes and 12 seconds.
2.3.3 GPS menu
:
Load GPS position:
This function shows the GPS positions that have been uploaded to the compass. Uploading is done
via the Windows program: K22 DPV. Here you can put known GPS locations (eg. wreck locations)
in the table and upload them to the compass.
Waypoints:
- Above water: use the active GPS location as the starting point. Then choose the destination
from the list of GPS points.
- Underwater: choose a previously entered GPS point from the list. This point must of course
correspond to the current location. Then select the destination.
The route can be started. Once arrived at the destination, a new location can be selected (under
water). You will be asked whether the current location should be used as the starting point. Answer
with “yes”. The new route is
shown. Make sure that this starting point is the actual GPS point.
If you
answer “no”, the compass
returns to the main menu. If necessary, you can ascend to surface
for an active GPS location and plan a new route.
