G915
D
May 05
10
Attaching the gate bracket to the leaf
The gate bracket connects the secondary arm to the gate leaf.
Position it after following the preceding diagrams. The primary and secondary arms must
never be less than 5 degrees off a straight line from each other.
Choose a point which is less likely to deflect under load. If necessary, weld support around
the area where the bracket must be positioned.
Mounting the operators to the gate posts
There should not be any visible
flexing of the mounting points under
load. To spread the load, all mounting
holes should be used.
Mount the centre line of the bracket
130 mm from the inside edge of the
gate post.
Use fasteners of at least 10 mm
diameter x 75 mm length.
Rising hinges
If rising hinges are fitted (to raise the gate as it turns, providing clearance above a sloping
driveway) then the joints on the opener arms can only allow 70 mm of rise, and 70 mm of
fall.
Board setup
It is strongly recommended to follow the procedures in the order below:
1.
Make all Connections
2.
Set the application mode
3.
Learn a remote control
4.
Set motor limit cams
5.
Run Easy Setup
6.
Adjust Controls
7.
Run Professional or Easy Setup again
8.
Learn wireless remote controls
20
130 for 90º opening
190 for 120º opening
Содержание G915D
Страница 23: ...23...
