Revised 08.2021
4-11
Operator’s Manual: 405 SLD Seed Express
™
Bulk Seed Tender
®
®
4.3.8 Remote Control Handset:
The handset is powered by two AA batteries. The
handset display window indicates the remaining
battery life. When batteries are new, the display
indicates 100% power. As the control is used,
the power decreases. When red indicator light
turns ON, the batteries should be replaced
immediately, or discontinue the using it.
Battery Replacement Tips:
• Check the batteries at least every six months
(for low Voltage, leakage, etc.).
• Always use the correct size and type of battery.
Replace old batteries with new 1.5 Volt AA,
alkaline batteries.
• Always replace both batteries at the same
time.
• Do not mix types, brands, or ages of
replacement batteries.
• Do not install the batteries backwards. Make
sure you insert the batteries with the + (plus)
and – (minus) terminals aligned correctly.
• Remove the batteries from the controller if not
expected to be in use for several months.
• Do not attempt to recharge a battery unless it
is specifically marked “rechargeable.”
• Dispose of old batteries properly.
Battery Replacement:
1. Remove the two Phillips head screws from
the cover on the back of the unit.
2. Replace the batteries, making sure they are
correctly positioned.
4.3.9 Remote Control Handset to Control
Panel Receiver Synchronization:
To reprogram the ID code to the receiver:
Note:
Do not interrupt this procedure
before it has completed or the system
may not operate correctly.
1. Turn the handset and control panel OFF.
2. Press and hold the POWER button on the
handset for more than ten seconds.
- The handset LCD display will indicate
when to apply power to the control panel.
3. When directed, apply power to the receiver.
- Green LED stays on constantly when
reprogramming is in progress.
4. When the process is completed, the green
LED will blink on and off.
- Test the handset transmitter to make sure
it functions properly.
4.3.10 Changing Handset Sleep Time:
To change the sleep time on the handset:
1. With the handset off, press and hold ENGINE
STOP, CONVEYOR STOP and POWER
buttons.
2. Wait for a few seconds, then release the
buttons.
3. The green and red LEDs will start blinking
together.
4. Use CONVEYOR INC and CONVEYOR
STOP to increase/decrease the sleep time.
5. Select the desired sleep time.
6. Press POWER button to save and exit.
Содержание 405 SLD SEED EXPRESS
Страница 6: ...This page intentionally left blank...
Страница 20: ...2 10 Revised 08 2021 Operator s Manual 405 SLD Seed Express Bulk Seed Tender This page intentionally left blank...
Страница 68: ...5 2 Revised 08 2021 Operator s Manual 405 SLD Seed Express Bulk Seed Tender This page intentionally left blank...
Страница 72: ...6 4 Revised 08 2021 Operator s Manual 405 SLD Seed Express Bulk Seed Tender This page intentionally left blank...