Merging Anubis Premium, Руководство пользователя

Страница: 134 / 138

134
"ASIO Clock Error : latency of
the master Horus/Hapi and
ASIO driver must be set
accordingly" in Merging
Ravenna ASIO Panel Driver compatibility The Merging RAVENNA ASIO driver version for Anubis must be V12
(or above)
Driver or Device
Latency
Configuration The latency between the ASIO driver and the Anubis device must be
from the same multiple set; AES67 (48 - 12 - 6) or 64 (64 - 32 -16).
See Anubis Settings > General > Frame Mode : Latency setting.
If you have multiple devices on your network, this setting can only be
configured on the Master PTP device.
Using Reaper, the audio
disconnects Reaper
Configuration In Reaper, the default behavior is to turn off the audio device when the
application is inactive (when you are outside the application)
Go in Reaper Options > Preferences > Audio and untick the "Close
audio device when stopped and application is inactive".
Anubis does not follow the
sampling rate changes of the
DAW or System Auto Sampling Rate Under the Anubis>Settings>General enabled the Auto Sampling Rate
option. The Auto sampling rate should follow provided at least one
RAVENNA ASIO or Virtual Audio Device stream is connected to an
Output of the Anubis.
ANEMAN Sampling
Rate Zone Launch ANEMAN and in the world view create a New Sampling rate
Zone, select your RAVENNA ASIO or VAD driver and drag this one on
the Crown within the Zone, then drag the Anubis in the Zone as well.
Monitor your PC sounds
(YouTube, Spotify,...) using
Anubis with similar use as a
built-in soundcard, with a
WDM bridge.
Requires third party
applications Refer to the Merging’s Knowledge Database WDM -ASIO configuration
proposal
https://confluence.merging.com/pages/viewpage.action?pageId=45449312
Warning: Merging’s RAVENNA ASIO is not multi -clients and cannot be
used simultaneously with a DAW if configured with a WDM bridge.
Merging is investigating solutions.
Some of the Anubis Sources
or Monitors cannot be
activated under their
respective Settings
Exceeding the
maximum channel
count available The total channels used for Sources or Monitors available is most
probably exceeded. Disable some of the other Sources or Monitors in
use, or delete unused ones, then reactivate your Source or Monitor.
Refer to the table here for information on the maximum channel count
that can be used for either the Sources or Monitors.
Using Pyramix the Anubis
Preamps remote control are
not supported on all versions
of Pyramix.
Version dependent. The Anubis remote preamps control support within the Pyramix Mixer
is supported as of Pyramix MassCore v11.1.6 Hotfix and on all
Pyramix Native version running ASIO v12 (64 bit).
Note some parameters such as Boost, Link and Cut are not
supported.