Mercury Xi5 Wireless Edition, Руководство пользователя, Страница: 49 / 53

NOTE: If all four buttons on the remote are not pressed simultaneously within
ten seconds, or a long beep is not heard, unplug the battery cables from the
power source and then refer to
Activating the Wireless Foot Pedal
and
Activating the Handheld Remote
in the
Product Installation, Wiring, and
Battery Information
section of this manual.
REPROGRAMMING THE WIRELESS FOOT PEDAL OR REMOTE
NOTE: This activation procedure applies to the foot pedal and handheld
remote.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1. Unplug the battery cables from the power source. Wait 30 seconds and
then plug the motor into the power source.
2. In less than ten seconds, press and hold the
left arrow
and
right arrow
buttons on the handheld remote. For the foot pedal controller, hold the
propeller
and
anchor
button simultaneously.
FOOT PEDAL BATTERY REPLACEMENT
Battery required: Two AA alkaline batteries
1. Remove the two screws securing the battery cover plate. Remove the
battery cover plate.
a - Battery cover plate
b - Screws
2. Remove the batteries from the battery holder.
3. Install the new batteries in the proper orientation for correct polarity.
ab
a
51760
OWNER SERVICE ASSISTANCE
eng
43