Mercury Xi5 Wireless Edition, Руководство пользователя, Страница: 24 / 53

Activating the Wireless Foot Pedal
Each wireless foot pedal and wireless handheld remote has a unique serial
number, and each wireless controller must be synced individually to the trolling
motor receiver. The trolling motor receiver can sync up to 40 wireless
controllers. This ensures that the trolling motor will respond to commands only
from designated controllers. Follow the instructions below to activate a wireless
controller with your trolling motor. For erasing and reprogramming information,
refer to
Troubleshooting the Foot Pedal and Handheld Remote
in the
Owner Service Assistance
section.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1. Connect the battery cables to the battery, or plug in the battery cable to a
power source. Within ten seconds of connecting the battery cables to their
terminals, press and hold the
propeller
and
anchor
buttons on the
wireless foot pedal simultaneously.
2. Listen for a multitone beep, indicating that the receiver has synced the
electronic serial number.
a -
Anchor
button (foot
pedal on/off)
b -
Propeller
button
(propeller on/off)
3. To turn the pedal on or off, press and hold the
anchor
button. One beep
from the foot pedal indicates that the foot pedal is turned on, two beeps
indicate that the foot pedal is turned off.
Activating the Handheld Remote
1. If the trolling motor battery cables are connected, disconnect the battery
cables from the trolling motor battery, starting with the negative (–) lead.
2. Connect the battery cables to the battery or plug in the battery cable to a
power source. Within ten seconds of connecting the battery cables to their
terminals, press and hold the
left arrow
button and
right arrow
button on
the handheld remote simultaneously.
a
b
51767
PRODUCT INSTALLATION, WIRING, AND BATTERY
INFORMATION
18
eng