Mercury VesselView 7, Руководство пользователя

Страница: 16 / 61

Section 2 - System Startup
Page 12 90-8M0074777
eng
MAY 2013
VesselView 7 Startup Warning Screen
When VesselView 7 is started, a warning screen pops up and advises the operator not to rely on the product as a primary
source of navigation and that the user assumes all liability for operation and associated risks.
Initial Startup
VesselView must be programed for the vessel personality. The vessel personality can be created by three different methods:
with Mercury Marine G3, a micro SD card the OEM has saved the data to, or through the onboard menu system. The vessel
personality may include, but is not limited to: the number of engines, the number of helms, the number and type of tanks, and
the type of sensors installed on the vessel.
•
If a personality has been loaded with G3 or a micro SD card, and it is a single‑display installation, then no setup or
installation dialog is required.
• When multiple VesselView displays are installed, these devices will be self‑discovered. A popup will appear informing that
multiple devices are installed. The station and display number must be selected through on‑screen prompts.
• If a personality has never been loaded into the product, then VesselView will use the default setup based on what is
discovered by querying the SmartCraft protocol for engine and type of drive. Further customization can be performed with
the onboard menu system.
Splash Screen
When the ignition key is turn on, a Mercury startup splash screen will appear. The number of engine hours will be displayed for
up to 4 engines. The number of hours is supported up to 9,999 hours. In the lower right corner of the screen is the software
version. Power packages with emissions control will show an engine icon in the lower left hand corner of the screen.
51617
Mercury splash screen
Device Configuration
The VesselView device configuration guides you through the first steps to configure the VesselView. VesselView device
configuration begins when the VesselView unit is turned on for the first time or when a factory reset is performed.
These settings and more can be changed at any time in the Settings menu.
1. Turn all engine key switches to the on position and the WELCOME screen will appear.