Mercury MerCruiser 4.3 TKS, Руководство пользователя

Страница: 38 / 122

Section 3 - On The Water
Page 30 90-899883179 OCTOBER 2007
b. Turn ignition key to "START". Release key when engine starts and allow switch
to return to "ON" position.
6. Inspect the power package for fuel, oil, water and exhaust leaks.
7. Move control handle with a firm, quick motion forward to shift to forward gear, or
backward to shift to reverse. After shifting, advance throttle to desired setting.
NOTICE
Shifting into gear at engine speeds above idle will damage the gearcase. Shifting into
gear when the engine is not running can cause misalign the clutch, preventing proper
shifting. Always shift the gearcase into gear when the engine is operating at idle. If you
must shift while the engine is not operating, rotate the propeller shaft in the appropriate
direction during shifting.
STOPPING THE ENGINE
1. Move the remote control handle to neutral/idle and allow the engine to slow to idle
speed. If engine has been operated at high speed for a long period of time, allow the
engine to cool at idle speed for 3 to 5 minutes.
2. Turn ignition key to the "OFF" position.
Starting the Engine After It Has Been Stopped While In Gear
IMPORTANT: Avoid stopping the engine if the sterndrive unit is in gear. If the engine does
stop, refer to the following procedure:
1. Push and pull repeatedly on the remote control handle until handle returns to the
neutral/idle position. This may take several tries if the power package was operating
above idle RPM when the engine stopped.
2. After the handle returns to the neutral/idle position, resume normal starting procedures.
Throttle‑Only Operation
1. Refer to
Remote Controls
section for remote control features.
2. Move the control lever to the idle/neutral position.
3. Depress and hold the throttle only button, and move the control lever to the idle/forward
or idle/reverse position.
4. Advancing the control lever beyond the idle/forward or idle/reverse position will cause
engine speed to increase.
IMPORTANT: Moving the control lever back to the idle/neutral position will disengage the
throttle only button and allow the engine to shift into gear.
5. Throttle only mode is deactivated by moving the control lever to the idle/neutral position.
Moving the control lever from the idle/neutral position to the idle/forward or idle/reverse
position without pressing the throttle only button will shift the unit into the chosen gear.
Trailering the Boat
Your boat can be trailered with the sterndrive unit in the up or down position. Adequate
clearance is required between the road and sterndrive when transporting.
If adequate road clearance is a problem, place the sterndrive unit in full trailer position and
support it with an optional trailer kit which is available from your authorized Mercury
MerCruiser dealer.
Freezing Temperature Operation
IMPORTANT: If the boat is operated during periods of freezing temperature, precautions
must be taken to prevent freeze damage to the power package. Damage caused by
freezing is not covered by Mercury MerCruiser Limited Warranty.