18
Fender
Champion “600”
•
Mercury Upgrade Kit
This project and its documentation is the result of technical investigations made by the engineering staff of
Mercury Magnetics
. The disclosure of the information herein may pertain to proprietary rights and
the furnishing of these documents does not constitute an expresed or implied license to use such materials.
Choke prep reference
photographs.
Using a 1/16” bit, drill 2 holes as indi-
cated by these photos. You may need
to reference the schematics to locate
their exact positions. The holes are for
the 2 leads from the choke. The holes
should just clear the trace. Take a sharp
knife and scrape away the insulation
layer above the trace next to each hole.
Then, tin the new contacts with a small
amount of solder.
1.
Drill the first 1/16” hole next to the trace. For the
location, see the schematics. It is near the location of R11.
2.
Drill the second 1/16” hole next to the trace. For the
location, see the schematics. It is near the location of C12.
3.
Scrape off the insulation over the traces, next to each
of the holes you’ve just drilled. Scrape just enough to
allow for good contact.
4.
A close-up of the insulation scraping.
5.
Tin the traces in prep for the choke leads.
2
1
Содержание Champ 600
Страница 1: ...VERSION 040711 ...
