CDS G3 INTERFACE KIT
90-8M0101386 DECEMBER 2014
Page 5 / 8
5. Another pop‑up window will open, asking if you want to allow the program to make changes to your computer. Click on
Yes
. The installation will begin. Once completed, CDS G3 will open with the new software version.
G3 Harness Connections
Connection to the Engine
1. Insert the CDS G3 SmartCraft diagnostic interface USB connector into a powered USB port on the computer. The green
power (PWR) light on the CDS G3 SmartCraft diagnostic interface will illuminate to indicate that it is powered up.
2. Connect the SmartCraft diagnostic interface 9‑pin connector to the CAN P/CAN H adapter harness 9‑pin connector.
3. Connect the CAN P/CAN H adapter harness to the G3 engine harness adapter.
4. Remove the CAN P termination resistor from the engine harness. Refer to the appropriate service manual for the location
of the CAN P connector.
5. Connect the G3 engine harness adapter to the CAN P engine harness connector.
IMPORTANT: The G3 engine harness adapter (84‑8M0046081) contains the correct termination resistor for the CDS G3
SmartCraft diagnostic interface to communicate on the CAN bus circuit.
a -
Computer
b -
CDS G3 SmartCraft diagnostic
interface
c -
CAN P/CAN H adapter
harness
d -
G3 engine harness adapter
e -
Connector—to CAN P engine
harness connector
Connection to the Junction Box
1. Insert the CDS G3 SmartCraft diagnostic interface USB connector into a powered USB port on the computer. The green
power (PWR) light on the CDS G3 SmartCraft diagnostic interface will illuminate to indicate that it is powered up.
2. Connect the SmartCraft diagnostic interface 9‑pin connector to the CAN P/CAN H adapter harness 9‑pin connector.
3. Connect the CAN P/CAN H adapter harness to the junction box.
a
b
c
d
e
47947
