Mercury 600.219, Инструкция по эксплуатации

Страница: 21 / 56

DC VOLTAGE MEASUREMENT
1) Connect the red test lead to the "V/ Ω " jack and the black
test lead to the "COM" jack.
2) Set the Function / Range switch to the desired “ ” range . If
the voltage to be measured is not known beforehand, set
the switch to the highest range and then turn down range by
range until satisfactory resolution is obtained.
3) Connect the test leads to the source or load to be
measured.
4) Read the voltage value displayed on the.
DC CURRENT MEASUREMENT
1) [600.219]
Connect the black test lead to the "COM" jack and the red
test lead to the "mA" jack (While the current to be measured
is between 200MA and 20A, remove the red test lead to the
“20A” jack.)
[600.524]
Connect the black test lead to the "COM" jack and the red
test lead to the "2A" jack (While the current to be measured
is between 2A and 20A, remove the red test lead to the
“20A” jack.)
2) Set the Function / Range switch to the desired “
” range. If
the current to be measured is not known beforehand, set the
switch to the highest range and then turn down range by
range until satisfactory resolution is obtained.
3) Open the circuit in which the current is to be measured, and
connect the test leads in series with the circuit.
4) Read the current value displayed on the LCD along with the
polarity of the red test lead.