Keyless entry keypad procedure
1. Turn the ignition to the off position.
2. Close all doors, the liftgate and liftgate window.
3. Enter 5–digit entry code
4. Press and hold the 3
•
4. While holding the 3
•
4 press the 7
•
8.
5. Release the 7
•
8.
6. Release the 3
•
4.
The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.
Message center procedure
For information on activating/deactivating the autolock feature using the
vehicle’s message center (if equipped), refer to
Message center
information in the
Driver Controls
chapter.
Autounlock
The autounlock feature will unlock all the doors when:
•
the ignition is in the on position, all the doors are closed, and the
vehicle has been in motion at a speed greater than 12 mph (20 km/h);
•
the vehicle has then come to a stop and the ignition is turned to the
off or accessory position; and
•
the driver door is opened within 10 minutes of the ignition being
transitioned to the off or accessory position.
Note:
The doors will not autounlock if the vehicle has been
electronically locked before the driver door is opened.
Deactivating/activating autounlock
Your vehicle comes with the autounlock feature activated. There are four
methods to enable/disable this feature:
•
Through your authorized dealer, or
•
Performing the power door lock control procedure, or
•
Performing the keyless entry keypad (if equipped) procedure, or
•
Performing the message center (if equipped) procedure.
Before following the activation or deactivation procedures, make sure
that the anti-theft system is not armed, ignition is in the off position, and
all vehicle doors, liftgate and liftgate window are closed.
2009 Mountaineer
(mnt)
Owners Guide, 1st Printing
USA
(fus)
Locks and Security
143
