Mercedes-Benz smart Wallbox Home, Руководство по установке

Страница: 17 / 36

smart Wallbox Preparations, installation and taking into operation 13
4. Use the TX30 screwdriver to insert two of the four 6 x 60 chip-
board screws included into the two upper drill holes and tighten
to a distance of 4 mm from the wall.
5. Place the Wallbox onto a work surface and open the lockable
screw at the lower edge of the housing base using the housing
cover key provided. Then flip the housing cover up and remove
it.
Note:
Protect the housing cover from scratches and other types
of external damage. Only remove the protective film from the
housing cover as your last step, immediately before completing
installation.
6. In the upper part of the Wallbox, use the TX20 screwdriver to
loosen the M4 screw, which is used to fix the internal electronic
components cover to the housing base, and remove the electro-
nic components cover. Keep the screw in a safe place.
7. Make a cut into the membrane of the largest grommet
w
: Now
insert the supply cable through this opening.
Note: The two smaller openings sealed with grommets
q
are
needed for connecting with an external charge control modu-
le, e.g. via the smart Wallbox Advanced. Please see the relevant
information on connections in the installation manual for the
smart Wallbox Advanced, available at:
www.yourwallbox.de/downloads/smart/Advanced/
8. Hang the housing base of the Wallbox at the installation site.
There are two integrated screw slots
u
in the upper part of the
back of the housing base to fit over the screws installed in step
4. The smart Wallbox Home is now preinstalled at the installati-
on site.