Mercedes-Benz CLS 2012, Руководство пользователя

Страница: 342 / 405

X
Pull plug ? with the cable and hose A out
of the housing.
X
Screw hose A onto flange B of tyre seal-
ant bottle : .
X
Place tyre sealant bottle : head down-
wards into recess ; of the tyre inflation
compressor.
X
Remove the cap from valve C on the faulty
tyre.
X
Screw filler hose D onto valve C .
X
Insert connector ? into a 12 V socket
(
Y
page 308) in your vehicle.
Observe the notes on sockets
(
Y
page 308).
X
Turn the key to position 1 in the ignition
lock (
Y
page 147).
X
Press on/off switch = on the tyre inflation
compressor to I.
The tyre inflation compressor is switched
on. The tyre is inflated.
i
First, tyre sealant is pumped into the tyre.
The pressure can briefly rise to approx-
imately 500 kPa (5 bar/73 psi).
Do not switch off the tyre inflation com-
pressor during this phase.
X
Let the tyre inflation compressor run for
five minutes. The tyre should then have
attained a pressure of at least 180 kPa
(1.8 bar/26 psi).
If a tyre pressure of 180 kPa (1.8 bar/
26 psi) has been attained after five minutes:
(
Y
page 339).
If a tyre pressure of 180 kPa (1.8 bar/
26 psi) has not been attained after five
minutes: (
Y
page 339).
i
If the tyre sealant leaks out, allow it to dry.
It can then be removed like a layer of film.
If you get tyre sealant on your clothing,
have it cleaned as soon as possible with
perchloroethylene.
Tyre pressure not reached
If a pressure of 180 kPa (1.8 bar/26 psi) has
not been achieved after five minutes:
X
Switch off the tyre inflation compressor.
X
Unscrew the filler hose from the valve of
the faulty tyre.
X
Very slowly drive forwards or reverse
approximately 10 m.
X
Pump up the tyre again.
After a maximum of five minutes the tyre
pressure must be at least 180 kPa (1.8 bar/
26 psi).
G
WARNING
If the required tyre pressure is not reached
after the specified time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance. Damaged tyres and a tyre
pressure that is too low can significantly
impair the vehicle's braking and driving char-
acteristics. There is a risk of accident.
Do not continue driving. Contact a qualified
specialist workshop.
Tyre pressure reached
G
WARNING
A tyre temporarily sealed with tyre sealant
impairs the driving characteristics and is not
suitable for higher speeds. There is a risk of
accident.
You should therefore adapt your driving style
accordingly and drive carefully. Do not exceed
the specified maximum speed with a tyre that
has been repaired using tyre sealant.
Flat tyre
339
Breakdown
assistance
Z