INSTALLATION INSTRUCTIONS
8
Rev 2.0
Mercator Pty Ltd. All Rights Reserved.
8.
Remove the sticky tape on the draft stopper
9.
Draw wires out from cut out hole and make wiring
connection in accordance to the wiring diagram
provided. The product must be earthed during
installation. Connect ducting to outlet and secure its
connection.
Insert heater into cut out hole at an angle ensuring duct
connection is intact and no cable or insulating material
rest over or against the heater.
Make sure side clamps are pulled inwards so that the
rest of housing can pass through the hole without
damaging plaster board.
Tips:
Do not overtighten clamp when securing ducting to air
outlet to allow draft stopper fully open in operation.
