System Wiring
All ZONE and TAMPER inputs are linked out prior to
despatch from the factory. Remove these links from
those zones which are to be used, but leave the links in
unused zones.
The EXIT TERMINATOR link MUST BE
REMOVED even if this facility is not used, otherwise all
programmed information will be lost on total power loss
(mains and battery).
PLANNING AND INSTALLING THE WIRING:-
1.
Ensure that the mains cable, circuit cables and
telecom cables are kept separate, and that mains
cable enters the housing as near to the fused
terminal block as possible.
2.
Ensure that the circuit, tamper and remote keypad
cables are not routed adjacent to AC or RF cabling
and are not run in multicore cables with bells or
sounders.
3.
Insulation testing should only be carried out when
the cable under test is disconnected from
electronic circuitry at both ends.
NOTE: TS500 Aux TMP = Main & Bell TMP
OP1 = WLK TST
OP2 = SW 12V
496525 Issue A
3 of 10
TS510 & TS500
TS510 & TS500
ALARM
TAMPER
Normally
Closed
P.A. Button
Normally
Open
Keyswitch
Normally
Open
Pushbutton
Alarm
Tamper
ALARM
TAMPER
0V
+12V
MOVEMENT DETECTOR
WIRED END OF LINE
MAGNETIC
CONTACT
WIRED
DOUBLE POLE
- VE STROBE TRIGGER
-VE BELL TRIGGER
STROBE
-
+
-VE TAMPER RETURN
S.A.B/SIREN
16 0HM
LOUDSPEAKER
STB -
H/O
O/P1
BELL TR -
AC
IN
AUX 12V
ZONE 1
ZONE 2
TAMP 1
TAMP
TAMP
ALM
ALM
2K2
4K7
2K2
TO
ZONE
2K2 (2200) OHMS
RED RED RED
END OF LINE RESISTOR
4K7 (4700) OHMS
YELLOW VIOLET RED
SHUNT RESISTOR
TAMP2
ZONE3
ZONE 4
TAMP 3
ZONE 5
EXIT TERM
TAMP 5
KEYSW/
F. EXIT
AUX TMP
P.A.
TAMP 4
O/P2
+
-
L/S+
TRG -
+12 V
0V
4K7
2K2
+
-
Fig 2 SAMPLE Wiring Diagram (showing Double Pole and End of Line Resistor wiring)
