Mendota DXV-60, Инструкция по установке и эксплуатации

Страница: 26 / 86

85-03-01115 DXV35 TIMBERFIRE Page 26
Marble, Granite and Natural Stones
Marble, granite and other natural stone products are approved for use as mantel, facing and hearth pad materials with the
following limitations and understanding of these cautionary statements:
Never use a one-piece marble, granite or natural stone that is water jet or mechanically cut in a U -shape
as facing material to cover the sides and top ar eas around this product. Doing so can lead to crack
formation at the inner corners of the U shape due to thermal expansion.
Figure 3-27 Three Piece Stone
Most marble slabs and marble tiles contain a polyester resin coating while most granite slabs and granite tiles contain epoxy
resin coatings. The polyester resin coatings and the epoxy resin coatings provide structural strength to the stone slabs and
prevent cracking, chipping and breakage during shipping and handling. These coatings also provide a glossy or satin surface
finish and help seal the stone surface.
The polyester resin used on marble slabs can discolor when exposed to temperatures greater than 150
o
F
and will structurally fail at temperatures abo ve 230
o
F. The epoxy resin coating used on granite slabs are
resistant to discoloring and structural failures up to 3 50
o
F.Mendota does not assu me any liability for
discoloring, flaking or cracking of marble or granite.
Temperatures on facings around Mendota Gas Fireplaces can reach
350
o
F directly outside the top convection air gap and as high as 210
o
F
at the maximum allowed mantel protrusion level above the top
convection air gap. These temperatures can discolor polyester resin
coated marble facings and can cause the polyester resin coating to fail
near the top convection air gap.
Mendota Fireplace cannot guarantee suitability of use of
any marble slabs or tiles that have a polyester resin coating
applied to it and cannot guarantee against discoloration or
structural failure of marble or polished stone facings that
have a polyester resin coating. Consu lt with your local stone
supplier.
Prior to use of any marble, granite or polished stone facing material,
especially white colored ones, run heat exposure tests on a sample piece. Expose sample pieces to temperatures between
275
o
F and 350
o
F for a period of eight hours. Compare the heat exposed sample to a control unheated piece and judge for color
changes. Do not use if any color changes are evident.
Mendota recommends the use of honed bare marble and bare stone facing materials or honed bare granite
and epoxy resin coated granite only.
Mendota cautions that due to natural structural defects that can exist within marble and stone pieces, cracking and/or flaking
of the marble or stone is possible and must be considered prior to selection and application around Mendota Fireplaces.
Mendota further cautions that proper adhesives be used to attach stone facings. Pay attention to the potential of off-gassing of
chemical vapors from mastic and other adhesives. Improper selection can lead to emission of chemicals with unwanted smells.
Figure 3-28 Top Air Gap