18 of 24
1. Spray anti static on the back of the fire behind the screen and on the silk.
2. Attach the silk and clip back into its original position.
3. Clean the effects screen and outer screen with screen cleaner and cloth.
4. Clean the glass with glass cleaner and cloth.
5. Connect / restore mains electricity and on/off switch back-to 1 position.
6. Run the fire while the screen is unattached following
7. Steps 1, 2 and 3, for 5 minutes.
8. Turn off the fire from your handset.
9. Attach screen.
10. Run the fire while the screen and door closed following steps 4.2.1, 4.2.2 and 4.2.3, for 3 minutes.
CLEANING
DO NOT
use water, detergents, abrasive cleaning powders or polish of any kind on the body of the
appliance, lightly dust using a dry duster or a medium soft brush.
To clean the glass use glass or window cleaner.
SERVICING INSTRUCTIONS
ONLY TO BE UNDERTAKEN BY A
TRAINED AND COMPETENT
ELECTRICAL ENGINEER.
To gain access to the unit for servicing the complete
assembly needs to be removed from the body of the
stove.
1) Disconnect the stove from the power supply,
removing the power cable from the rear of the
stove.
2) Open the door, this may need to be supported
from underneath due to its weight to stop the stove
falling forwards.
3) Remove all the fuel effect from the stove, clean if necessary.
4) Locate the 4 x 13mm nuts in the top of the stove which hold
the top plate to the body and remove these. Then li� the top
plate from the body. This exposes the LED Driver and printed
circuit board. The ON/OFF switch can be replaced if required at
this stage.
5) Remove the 12 Phillips screws and 2 holding brackets from
the rear of the stove.
6) Remove the 10 Allen head screws from the front panel.
7) The whole unit can now be li�ed from the body. This may require 2 people due to the weight.
8) To replace, reverse the steps 1 to 7.
