Getting Started
MEN Mikro Elektronik GmbH
22
20G020-00 E5 – 2014-01-21
1.3
Integrating the Board into a System
You can use the following check list when installing the G20 in a system for the first
time and with minimum configuration.
Power-down the system.
Remove all boards from the CompactPCI system.
Insert the G20 into the system slot of your CompactPCI Serial system, making
sure that the CompactPCI Serial connectors are properly aligned.
Note: The system slot of every CompactPCI Serial system is marked by a tri-
angle on the backplane and/or at the front panel. It also has red guide
rails.
Connect a USB keyboard and mouse to the USB connectors at the front panel.
Connect a display to the Display Port connector at the front panel.
MEN offers a DisplayPort to DVI-D Adapter as an accessory. See MEN’s
web-
site
for ordering information.
Power-up the system.
You can start up the BIOS setup menu by hitting the <F2> key (see
Chapter 3
BIOS on page 54
).
Now you can make configurations in BIOS (see
Chapter 3 BIOS on page 54
).
Observe the installation instructions for the respective software.
