MEMOLUB HPS
®
Basic Program Settings
Copyright © 2003, PLI, LLC
MEMOs are the method used to set the output rate of the MEMOLUB Lubricator. Once
programmed, the MEMO is screwed into the bearing and remains there unless it is decided to
change the output rate. The MEMOLUB Lubricator is then screwed onto the MEMO. This turns the
lubricator on to eject lubricant at the rate of output programmed.
MEMOs are supplied with 3 colored plastic rings (black, white and red) and a black plastic ring
holder. The timing of lubricant ejection cycles is determined by which ring or combination of rings are
placed in the ring holder. The number of ejection cycles per day, determines the volume of lubricant
entering the bearing. With each output cycle, 0.63 cc’s of lubricant is injected into the bearing. The
rates of daily lubricant output using different ring combinations are shown in the following chart.
To inject daily quantities of lubricant into your bearing other than those shown in the
chart, refer to
. Using the “Stroke Limiting Washers” it is
possible to select from 52 different rates of injection.
®
®
Basic Settings
Fine Tuning Your Lubrication Program
MEMOS - Setting The Output Rate
MEMOLUB HPS
®
Lubricator Basic Settings (The Simple Approach)
Note: B = Black Ring / W = White Ring / R = Red Ring
Memo Program
Model
120 HPS
Model
240 HPS
Model
480 HPS
0.63
0.63
0.63
0.63
0.63
0.63
0.63
Rings
(color)
Strokes
Per Day
CC’s per
Cycle
Daily Output
in CC’s
Months
To Empty
Months
To Empty
Months
To Empty
RWB
RW
RB
R
BW
W
B
24
12
4
2
1.5
1
0.5*
15.1
7.6
2.5
1.3
1.0
0.6
0.3
0.5
1.5
3
4
6
12
0.5
1
3
6
8
12
24
1
2
6
12
16
24
* Ejection cycle every other day (48 hours)
MEMOLUB® HPS User’s Guide
Page 24 of 39
PLI, LLC
MEMOLUB® HPS User’s Guide
Page 24 of 39
PLI, LLC
