BX 4000 Sereies Quick Start Guide
Mellanox Technologies
Rev 1
.5
5
describe the side that has the power supply modules and the fan tray, and the term connector side to describe
the side that has the CX4 and SFP+ connectors.
The installer should use a rack capable of supporting the mechanical and environmental characteristics of a
fully populated platform.
Installing the Gateway in the Rack
BridgeX Gateway Platform Hardware Overview
Figure 4 shows the power side and connector side panel views of the gateway. The figure below shows dual
hot-swap power supplies and the hot-swap fan module on the power side, and port configurations for the
gateway systems and RS232, I2C, GigE connectors and various status LEDs on the connector side.
All connectivity is via the connector side panel. All connectors can support active cables.
Figure 3: MTB4010B Gateway System Power Side and Connector Side Panels
Package Contents
The package should include all of the following parts:
•
BridgeX Gateway
•
Installation kit for 19” Rack mounting
•
2 Power cables
The rack mounting holes conform to the EIA-310 standard for 19-inch racks. Take pre-
cautions to guarantee proper ventilation for air intake at the power side of the chassis
and exhaust at the connector side in order to maintain good airflow at ambient temper-
ature. Cable routing in particular should not impede the air exhaust from the chassis.
Power Supply Unit 1
90-264 V
47-63 Hz
8A max
Fan Unit
Power Side Panel
Optional
Power Supply Unit 2
90-264 V
47-63 Hz
8A max
1U
Connector Side Panel
B20
A20
1 GigE
I2C RS232
Sys
Fan
PSU 1
PSU 2
FC
EN
FC
EN
A1
B1
I2C
IOIO
A11
A12
A13
A10
B11
B12
B13
B10
~AC
OK
~AC
OK
Mellanox
®
BX4010
