Installation and Basic Operation
Rev 1.4
Mellanox Technologies
28
Figure 15: Making Room for the Power Cord
Figure 16: Screwing on the Bracket
3.
Screw the rails onto the gateway. Use 5 flat head screws to connect each rail to the gateway.
Figure 17: Screwing on the Rail
4.
Clip 4 caged nuts into the holes in the rack you will be using to connect the rail slides. Check
that both sides of the gateway, left and right, are the same level in the rack.
The side of the gateway with these brackets will be the side that is even with or close to
the vertical rack support.
Power cord
Place to run the
power cable
In this position you will
use 4 flat head screws
In this position you will
use 3 flat head screws
In this position the front of the gate-
way is even with the rack vertical sup-
port
In this position the front of the gateway is
~5cm behind the rack vertical support
5 screws
