![background image](http://html1.mh-extra.com/html/melissa/16440005/16440005_manual_1767882024.webp)
24
Recharging
• Charge the appliance fully before
using for the first time or after a long
period without use. This ensures
maximum battery capacity and long
service life. It takes around 6 hours
to fully recharge. The battery will
only function optimally after it has
been charged and discharged 2-3
times.
• Plug the supplied charger in and
insert the plug on the charger cord
into the charging socket on the
appliance.
• Press the ON/OFF button(8) on
top of the appliance. Note: The
appliance will not start to charge
if the ON/OFF button is not
positioned on ”ON”.
• The indicator light on the charging
socket (6) will come on and the
indicator light on the charger will
be red as long as the appliance
is charging. Once the indicator
light on the charging socket goes
off, and the indicator light on the
charger is green, the appliance is
fully charged.
• Please note: The appliance’s built-
in, rechargeable battery can be
found in the battery compartment
(10) in the base of the appliance.
Contact the retailer or service
workshop if the built-in battery
requires replacement. The battery
is a consumable item and is not
covered by the warranty.
Assembly before use:
• Check that the rotating brush (12) is
clean and that there is no hair, pile,
etc. wound around it.
• Make sure that the dust container
(2) and its dust filter are empty and
fitted correctly to the appliance.
• Check that the edge sensors (9) are
not covered or dirty.
• Make sure that the battery is
fully charged before you start the
appliance.
Preparing the room
• Remove any obstacles from the
floor, such as cables, loose objects,
etc. that may prevent the appliance
from functioning or get caught in
the brushes. There must be at least
40 cm between objects on the floor
if the appliance is to pass between
them.
• Remove all loose rugs.
• Be aware that the appliance may
get stuck under sofas and chairs,
for instance, if the clearance
beneath them is roughly the same
as the height of the appliance.
Use
• Place appliance in middle of the
floor to be cleaned.
• Switch the appliance on using
the on/off button (8) on top of the
appliance. The indicator light in the
button will come on.
• Start the appliance by pressing the
start/stop button (7).
• The appliance will run outwards in
a spiral. If the bumper sensor hits
an object, the appliance will change
direction. The edge sensors ensure
that the appliance does not fall
downstairs or over an edge.